Warning, Draining the dehumidifier – Whirlpool AD35DSS1 User Manual
Page 6
6
Desired Humidity
1. Press DESIRED HUMIDITY to select the desired humidity
setting.
2. Choose Normal, Dry, Max Dry or Continuous Run.
■
Normal—Will operate the dehumidifier at the selected fan
speed until the humidity levels are lowered.
■
Dry—Will operate the dehumidifier at the selected fan
speed until the humidity levels are lowered more than the
Normal setting.
■
Max Dry—Will operate the dehumidifier at the selected
fan speed until the humidity levels are lowered to the
maximum level.
■
Continuous Run—Will operate the dehumidifier
continuously at the selected fan speed regardless of
humidity level. The dehumidifier will turn off only if the
bucket is full or removed.
NOTE: The electronic control will cycle the compressor
on and off if a low temperature condition exists.
Pressing the Desired Humidity arrow will not increase
or decrease the amount of moisture removed during a
low temperature condition. Normal compressor operation
will resume when the low temperature condition no
longer exists.
Draining the Dehumidifier
Option 1—Remove Bucket
If a floor drain is not available, or you do not plan to run your
dehumidifier continuously, you may want to simply empty the
bucket.
1. Use front handle to slide bucket out.
2. Use front and back handles to lift bucket.
3. Pour water through opening into a sink or tub.
4. Reinstall bucket.
IMPORTANT: If the Empty/Adjust Bucket light comes on, the
dehumidifier will not operate. Empty or adjust bucket.
WARNING
Sickness Hazard
Do not drink water collected in water bucket.
Doing so can result in sickness.