Winegard RM-DM61/DM55 - Manual (Page 5)

5
INSTALLATION AND ASSEMBLY
THINGS YOU NEED
Screwdrivers (Phillips and slot)
1-3/4” hole saw
7/16” wrench Drill with 1/8” bit
Tape measure Sealant
(Must be approved for compatibility w/roof)
STEP 1. Choose a location on the roof for the unit. The dish must be able to rotate without interfering with other roof-
mounted equipment (air conditioners, etc.), Figure 4. Be sure the interior ceiling plate is easily accessible with no obstruc-
tions that may interfere with operation.
NOTE: Check with your dealer or vehicle manufac-
turer for features that may have been installed for
antenna mounting — reinforced roof areas or pre-wire
installation done at the factory.
THE SYSTEM MUST BE LEVEL FOR PROPER OP-
ERATION! Winegard’s RW-5000 roof wedge is available
for sloped roofs, Figure 5. If using roof wedge, installer
will provide longer mounting screws. Mount base plate
and ceiling plate must be parallel with each other,
Figure 5. If shims or wedges are used, the installer must
supply.
STEP 2. Position roof template (inserted in this manual)
on the roof. CAUTION: DO NOT drill through wiring.
Carefully drill a 1-3/4” hole through roof and ceiling of
vehicle. Inspect hole to make sure wiring is intact.
Mount base plate and ceiling plate must be parellel with each
other. if shims or wedges are needed, installer must supply.
FIGURE 5
FIGURE 4