Wybron NET IT PS600 - Manual (Page 14)

14
Front and Back Panels
See the diagram on the next page.
The Net IT has one IEC universal power connector.
There are two 5-pin XLR output ports located on the unit. These are labeled “Port A” & “Port B”
and output DMX/RDM on two universes.
The Net-IT PS-600 has six 4-pin XLR connectors for connecting Wybron products. They transfer
Universe A data and 24 volt DC power.
There is one Ethernet connector.
There are 5 LEDs that indicate the following:
- One green LED labeled “LAN” flashes if the Net-IT is connected to a network.
- One green LED labeled “100Mbps” that stays on if lit the link speed is 100Mbps.
- Two blue LEDs stay on if DMX is being transmitted on port A or B (happens during and
after Infogate Discovery command). They flash if DMX is being received from the
network.
- Two blue LEDs flash when RDM is being transmitted or received on port A or B.
The PAGE button is use to backlight the display and scroll through the different pages of
information.
If the RESET button is pressed and held for 10 seconds the Net-IT executes a factory default
reset.