Assembly – Weslo 450T User Manual

Page 4

1. Press a Stabilizer Endcap (13) onto each end of the

Long Stabilizer (8).

Attach the Long Stabilizer (8) to the indicated end of
the Base (2) with two M10 x 65mm Hex Head Bolts
(24), two Washers (25) and two M10 Locknuts (15).

ASSEMBLY

Place all parts of the stepper in a cleared area and remove the packing materials. Do not dispose of the packing
materials until assembly is completed. Assembly requires the included allen wrench , a phillips
screwdriver , two adjustable wrenches and a rubber mallet .

PART CHART

Use the drawings below to identify the small parts used in assembly. The number in parenthesis below each
drawing refers to the key number of the part, from the PART LIST on page 10. The second number refers to the
quantity used in assembly. Note: If a part is not found in the parts bag, check to see if it has been
preassembled.

M10 Locknut (15)Ð8

M4 x 10mm Screw (28)Ñ8

Washer (25)Ð4

M10 x 65mm Hex Head Bolt (24)Ð4

M6 x 12mm Button

Head Bolt (21)Ð4

M4 x 16mm Console

Screw (22)Р4