Assembly – Weslo WLTL223040 User Manual

Page 6

Make sure that the power cord is unplugged.

Orient the Base (28) so the holes for the four Base Pads
(19) are on top.

Open part bag A. Attach the four Base

Pads to the Base with the four 3/4” Tek Screws (24).

Attach the two Wheels (15) to the Base (28) with two 2”
Bolts (12) and two Wheel Nuts (29) as shown.

Do not

overtighten the Bolts. The Wheels must be able to
turn freely.

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of
the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there
is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own phillips screwdriver ,
adjustable wrench , wire cutters , and needlenose pliers .

For help identifying the assembly hardware, see the part drawings below. Note: The assembly hardware
and other small parts are packaged in separate part bags. Do not open the part bags until instructed to
do so.

5/16” Star Washer

(64)–4

3/8" Star

Washer (42)–6

6 1/2" Bolt (10)–2

3/4" Tek Screw (24)–4

2" Bolt (12)–6

Wheel Nut (29)–2

3/4" Screw (7)–10

Rack Screw (21)–12

3” Bolt (30)–4