White Rodgers 1F85-0422 - Manual (Page 7)

7
Set Current Time and Date
1) Press MENU and then TIME button once. The display
will show the hour only.
2) Press and hold either the or key until you reach
the correct hour and AM/PM designation (AM begins at
midnight, PM begins at noon).
3) Press TIME once again. The display window will show
the minutes only.
4) Press and hold either the or key until you reach
the correct minutes.
5) Additional presses of TIME will advance the display to
show the year, month and date of month. Press the
or
key to change the display to the correct setting
for each.
6) Press RUN SCHED to exit the TIME mode.
Enter the Heating Program
1) Press SYSTEM button to select “Heat” in the system
switch area indicating the active mode being pro-
grammed.
2) Press the MENU button and then press SCHEDULE.
3) The top of the display will show the day(s) being pro-
grammed. The time and temperature (flashing) are also
displayed. “1” will also be displayed to indicate the period.
4) Press or key to change the temperature to your
selected temperature for the 1st heating period.
5) Press TIME button, time will flash.
6) Press
or key to adjust the start time for the
1st period.
7) The time will change in 15 minute increments.
8) After you have set the time and the temperature for
the period to begin, press SCHEDULE to advance to the
next program period.
9) Repeat steps 2 through 8 until all of the program times
and temperatures are set for all program periods on that
day.
10) Press SCHEDULE to the next day and repeat steps 2
through 9.
11) When programming is complete and all of the times and
temperatures match your desired heating schedule, press
RUN SCHEDULE. The thermostat will now run your
program.
Enter the Cooling Program
1) Press SYSTEM button to select “Cool” in the system
switch area indicating the active mode being pro-
grammed.
2) Follow Enter Heating Program instructions for entering
cooling times and temperatures.
PROGRAMMING (For Programmable Model Only)
The 1F85-0422 thermostats are programmed with the energy
saving settings shown in the table below for all days of the
week. If this program suits your needs, simply set the thermo- stat clock and press the RUN SCHED button.
The table below shows the factory set heating and cooling
schedule for all days of the week.
Wake Up
(Period 1)
Leave For Work
(Period 2)
Return Home
(Period 3)
Go To Bed
(Period 4)
Heating
Program 6:00 AM
70°F 8:00 AM 62°F 5:00 PM 70°F 10:00 PM 62°F
Cooling
Program 6:00 AM
75°F 8:00 AM 83°F 5:00 PM 75°F 10:00 PM 78°F
Energy Saving ENERGY STAR ® Factory Pre-Program