Woods Equipment PRD6000 - Manual (Page 6)

6 Safety
PRD Mower (9/13/2005)
(Safety Rules continued from previous page)
„ Keep bystanders away from equipment.
„ Do not operate or transport equipment while
under the influence of alcohol or drugs.
„ Operate only in daylight or good artificial light.
„ Keep hands, feet, hair, and clothing away from
equipment while engine is running. Stay clear of all
moving parts.
„ Always comply with all state and local lighting
and marking requirements.
„ Never allow riders on power unit or attachment.
„ Always sit in power unit seat when operating
controls or starting engine. Securely fasten seat
belt, place transmission in neutral, engage brake,
and ensure all other controls are disengaged
before starting power unit engine.
„ Operate tractor PTO at 540 RPM. Do not exceed.
„ Look down and to the rear and make sure area
is clear before operating in reverse.
„ Do not operate or transport on steep slopes.
„ Do not stop, start, or change directions sud-
denly on slopes.
„ Use extreme care and reduce ground speed on
slopes and rough terrain.
„ Watch for hidden hazards on the terrain during
operation.
„ Stop power unit and implement immediately
upon striking an obstruction. Dismount power unit,
using proper procedure. Inspect and repair any
damage before resuming operation.
TRANSPORTATION
„ Use additional caution and reduce speed when
under adverse surface conditions, turning, or on
inclines.
„ Do not operate PTO during transport.
„ A minimum 25% of tractor and equipment
weight must be on the tractor front wheels when
attachments are in transport position. Without this
weight, tractor could tip over, causing personal
injury or death. The weight may be attained with a
loader. Weigh the tractor and equipment. Do not
estimate.
„ Do not operate or transport on steep slopes.
„ Do not operate or transport equipment while
under the influence of alcohol or drugs.
„ Always comply with all state and local lighting
and marking requirements.
„ Never allow riders on power unit or attachment.
MAINTENANCE
„ Before working underneath, carefully read Oper-
ator’s Manual instructions, disconnect driveline,
raise mower, securely block up all corners with
jackstands, and check stability. Secure blocking
prevents equipment from dropping due to hydrau-
li c l e ak dow n, hy dr a ul ic sy s tem fai l ur es , o r
mechanical component failures.
„ Do not modify or alter or permit anyone else to
modify or alter the equipment or any of its compo-
nents in any way.
„ Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
„ Make sure attachment is properly secured,
adjusted, and in good operating condition.
„ Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
„ Make certain all movement of equipment com-
ponents has stopped before approaching for ser-
vice.
„ Never go underneath equipment (lowered to the
ground or raised) unless it is properly blocked and
secured. Never place any part of the body under-
neath equipment or between moveable parts even
when the engine has been turned off. Hydraulic
system leak down, hydraulic system failures,
mechanical failures, or movement of control levers
can cause equipment to drop or rotate unexpect-
edly and cause severe injury or death. Follow Oper-
ator's Manual instructions for working underneath
and blocking requirements or have work done by a
qualified dealer.
„ Frequently check blades. They should be sharp,
free of nicks and cracks, and securely fastened.
„ Do not handle blades with bare hands. Careless
or improper handling may result in serious injury.
„ Your dealer can supply genuine replacement
blades. Substitute blades may not meet original
equipment specifications and may be dangerous.
SAFETY RULES
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!