Waterford Appliances EMERALD E63-NG1 - Manual (Page 19)

Waterford E63-1 EMERALD Freestanding Gas Stove 19
MAINTENANCE
10) Remove all 8 screws holding the burner
tray assembly in place.
11) Carefully lift the burner tray assembly out.
12) To replace the burner tray assembly, simply
reverse these instructions.
To remove valve from valve assembly,
continue.
13) Remove two (2) thermopile wires.
14) Remove thermocouple with a 9 mm (metric)
wrench.
15) Remove pilot nut with an 11 mm wrench.
16) Remove valve to orifice nut with a 5/8"
wrench.
17) Remove inlet pipe with pipe wrench. Note
orientation of 90 o elbow.
18) Remove two (2) phillips head M5 screws on
each side of the valve.
19) Remove valve and remove gas out 90 o
brass fitting. Note orientation of fitting.
INSTALLING VALVE
ASSEMBLY
1) To install a new valve assembly, reverse
instructions for removing valve. See
assembly steps 1-12.
2) Check for leaks and manifold pressure. See
Gas Pressure Test instructions.
3) To reinstall valve, reverse instructions for
removing valve assembly, steps 13-19.