weber 730 Series - Manual (Page 30)

30 30 30 30
e) Remove the manifold bracket and unscrew the two
wing nuts that hold the manifold to the cooking box.
Pull the manifold and valve assembly out of the
burners and carefully set it down. Figure 15.
View from behind
cooking box
Wing nuts
Figure 15
Guide screw
Figure 16
Crossover tube
Figure 17
Figure 14
d) Unlatch the Spider Stopper Guards and remove.
Figure 14.
g) Lift and twist the burner assembly slightly, to separate
the crossover tube from the burners. Figure 17.
Remove the burners from the cooking box.
f) Slide the burner assembly out from under the guide
screw and washer in the corners of the cooking box.
Figure 16.
h) To reinstall the burners, reverse steps c) through g).
ƽCAUTION: The burner openings must be positioned
properly over the valve orifices. Figure 18a.
Check proper assembly before fastening manifold in place.
Figure 18b.
Figure 18
Valve
Burner
(a)
(b)