White 21A-458B190 User Manual

Page 13

SECTION 12: OFF-SEASON STORAGE

If the tiller will not be used for a period longer than
30 days, the following steps should be taken to
prepare the tiller for storage.

Clean the exterior of engine and the entire tiller
thoroughly. Lubricate the tiller as described in
the lubrication instructions.

Refer to the engine manual for correct engine
storage instructions.

Wipe tines with oiled rag to prevent rust.

Store tiller in a clean, dry area. Do not store next
to corrosive materials, such as fertilizer.

NOTE:

When storing any type of power equipment

in an unventilated or metal storage shed, care
should be taken to rustproof the equipment. Using a
light oil or silicone, coat the equipment, especially
any springs, bearings and cables.

SECTION 13: TROUBLE SHOOTING GUIDE

Note: For repairs beyond the minor adjustments above, contact your local authorized service dealer.

Trouble

Possible Cause(s)

Corrective Action

Engine fails to
start

Fuel tank empty, or stale fuel.

Throttle control lever not in correct
starting position (if so equipped).
Blocked fuel line.
Dirty aircleaner.
Choke not in ON position.
Spark plug wire disconnected.
Faulty spark plug.
Engine flooded.

Fill tank with clean, fresh gasoline. Fuel will not last over
thirty days unless a fuel stabilizer is used.
Move throttle lever to start position.

Clean fuel line.
Refer to the engine manual packed with your unit.
Move switch to ON position.
Connect wire to spark plug.
Clean, adjust gap or replace.
Refer to the engine manual packed with your unit.

Engine runs
erratic

Unit running on CHOKE.
Spark plug wire loose.
Blocked fuel line or stale fuel.

Vent in gas cap plugged.
Water or dirt in fuel system.
Dirty air cleaner.
Carburetor out of adjustment.

Move choke lever to OFF position.
Connect and tighten spark plug wire.
Clean fuel line; fill tank with clean, fresh gasoline. Fuel will
not last over thirty days unless a fuel stabilizer is used.
Clear vent.
Drain fuel tank. Refill with fresh fuel.
Refer to the engine manual packed with your unit.
Refer to the engine manual packed with your unit.

Engine over-
heats

Engine oil level low.
Dirty air cleaner.
Air flow restricted.
Carburetor not adjusted properly.

Fill crankcase with proper oil.
Refer to the engine manual packed with your unit.
Refer to the engine manual packed with your unit.
Adjust carburetor as instructed in separate engine manual.

Tines do not
engage

Foreign object lodged in tines.
Tine clevis pin(s) missing.
Pulley and idler not in correct
adjustment.
Not shifting properly.

Control cable not adjusted properly.
Belt worn and/or stretched.

Dislodge foreign object.
Replace tine clevis pin(s).
Take unit to authorized service dealer.

Refer to Controls section of operator’s manual for proper
shifting procedures.
Adjust control cable (see assembly instructions).
Replace belt.

Tines skip over
ground

Improper rotation.

Forward rotation should only be used on soil that has
already been tilled, not on virgin soil.

Wheels do not
engage

Clevis pin missing.
Tiller is not being shifted properly.

Control cable not adjusted properly.
Belt worn and/or stretched.

Replace clevis pin.
Refer to Controls section of operator’s manual for proper
shifting procedures.
Adjust control cable (see assembly instructions).
Replace belt.