Weider WESY49310 - Manual (Page 14)

14
27. Locate the Low Cable (23). Route the Low
Cable under the 3 1/2” Low Pulley (102).
Be
sure that the end of the Cable with the ball
is on the indicated side of the Press Frame
(17) and that the Cable is between the
Pulley and the crossbar on the Press
Frame. Tighten the 3/8” Nylon Locknut (21)
and the 3/8” x 3 3/4” Bolt (not shown).
28. Wrap the Low Cable (23) around a 3 1/2”
Pulley (15). Attach the Pulley and a Cable
Trap (66) to the lower hole in the Front
Upright (42) with a 3/8” x 3 3/4” Bolt (88), a
3/8” Washer (9), and a 3/8” Nylon Locknut
(21).
See the inset drawing. Be sure that
the Cable Trap is turned to hold the Cable
in place and that the Cable and Pulley
move smoothly.
29. Route the Low Cable (23) around the 3 1/2”
Pulley (15) attached to the upper hole in the
Press Frame (17).
Be sure that the Cable
Trap (66) is turned to hold the Cable in
place and that the Cable is routed around
the Pulley as shown. Tighten the 3/8” Nylon
Locknut (21) and the 3/8” x 3 1/2” Bolt (not
shown).
30. Wrap the Low Cable (23) around a 3 1/2”
Pulley (15). Attach the Pulley and a Cable
Trap (66) to the upper hole in the Front
Upright (42) with a 3/8” x 3 3/4” Bolt (88), a
3/8” Washer (9), and a 3/8” Nylon Locknut
(21).
See the inset drawing. Be sure that
the Cable Trap is turned to hold the Cable
in place and that the Cable and Pulley
move smoothly.
30
27
23
28
Inset shows view
from other side
29
CABLE ASSEMBL
Y
21
17
Ball
42
21
23
23
21
15
15
88
9
42
66
66
Inset shows view
from other side
42
21
88
23
66
9
23 15
15
66
42
21
23
17
66
15
102
Crossbar
21