Weslo Daybreak SPRW52464 - Manual (Page 13)

13
be obtained at a pool and spa supply store. The pH
reading should be between 7.2 and 7.8.
If the level is too low, add half of one of the ÒQUICK
pHix It UPÓ packets to the water. Let the water circu-
late through the spa jet unit for five minutes. Test the
pH level again. Repeat until the pH level is correct.
If the level is too high, add half of one of the ÒQUICK
pHix It DOWNÓ packets to the water. Let the water cir-
culate through the spa jet unit for five minutes. Test
the pH level again. Repeat until the pH level is correct.
Replace the spa cover and allow the water to contin-
ue to heat.
See WATER CHEMISTRY on page 15 for information
concerning proper water maintenance.
SECURING THE SPA COVER
The spa cover can be secured by snapping the latch-
es on the spa cover into the buckles on the side panels.
The buckles can be
locked by inserting the
key and turning it
clockwise a quarter
turn. To unlock the
buckles, insert the key
and turn it counter-
clockwise a quarter
turn.
Always keep the buckles locked when the spa is
not in use. Keep the keys in a safe place, out of
the reach of children.
USING THE CONSOLE
Refer to the console diagram above. The function of
each console control is explained below:
Primer: This opening allows you to prime the spa jet
unit before operation (see PRIMING THE SPA JET
UNIT on page 12).
Diverter: Controls the flow of water through the
hydro-therapy jets and the whirlpool diverter. The
direction of the flow can be adjusted by turning the
diverter control. When the control is set to Òfront,Ó the
flow will be through the hydro-therapy jets; when it is
set to Òside,Ó the flow will be through the whirlpool
diverter; when it is set to Òall,Ó the flow will be evenly
distributed through both the hydro-therapy jets and
the whirlpool diverter.
Thermostat: Controls the temperature of the water.
The water heats at about 1.5¡F an hour with the cover
on. The thermostat can be set to heat the water from
70¡F to 104¡F. You should use a medical or other
accurate thermometer to check the temperature of the
water.
On/Off: Turns the spa jet unit on and off. To turn the
spa jet unit on, press the control once. To turn the spa
jet unit off, press the control twice. After you press it
once, the spa jet unit will shut off for about 30 sec-
onds, and restart. Press the control again. The spa jet
unit will remain off for three hours, at which time it will
begin running the filter cycle. At any time after the spa
jet unit has been shut off, the pump will begin cycling
the water if the temperature falls below the minimum
setting. Note: To keep the filter and heat cycles from
running, the power cord must be unplugged.
Air Control: Determines the amount of air that is in
the spa jet system during operation. If the control is
turned to the left, the amount of air flowing through
the jets will increase. If the control is turned to the
right, the amount will decrease.
DIAGRAM OF THE CONSOLE
Key
Latch
Buckle