Wells TCW-2 - Manual (Page 9)

CLEANING
7
PRECAUTIONS: Press power switch to OFF.
Allow drawer(s) to cool before proceeding.
Remove drawer pan(s)
FREQUENCY: Minimum - Weekly
TOOLS: Warm water and mild detergent
Clean cloth or sponge
1. Press power switch to OFF. Allow drawers to cool. Remove
product pan(s) and safely store or discard any remaining product.
2. Remove drawers and glides from warmer:
a. Pull drawer out until fully extended.
b. Raise front of drawer until front rollers clear glides. Continue
pulling drawer out until rear rollers clear glides.
c. Push glides all the way back in. Tilt bottom of glide toward
center of cavity, then lift off of fixed rollers.
3. Clean drawers and glides by wiping with a clean cloth dampened
with warm water and mild detergent. Product pans may be
cleaned as above, or in a dishwasher. Rinse all components
thoroughly by wiping with a clean cloth dampened with clean
water. Dry with a clean cloth.
4. Remove fan baffle by lifting up and out.. Clean fan baffle by wiping
with a clean cloth dampened with warm water and mild detergent.
Rinse by wiping with a clean cloth dampened with clean water.
Dry by wiping with a clean cloth.
5. Sweep crumbs and other debris from warmer cavity. Carefully
clean fan by wiping blades with a clean cloth or sponge dampened
with warm water and mild detergent.
6. Clean interior of cavity by wiping with a clean cloth or sponge
dampened with warm water and mild detergent. Rinse by wiping
with a clean cloth dampened with clean water. Dry with a clean
cloth. Be careful to avoid damaging thermometer or thermostat
bulbs or capillary tubes, which are exposed inside cavity.
7. Clean outside of the unit by wiping with a clean cloth or sponge
dampened with warm water and mild detergent. Dry with a clean
cloth, then wipe with a polish formulated for stainless steel.
8. Reinstall fan baffle(s), drawer glides, drawer(s) and product pan(s).
PROCEDURE IS COMPLETE
CAUTION:
HOT SURFACE
Exposed surfaces can be hot
to the touch and may cause
burns.
CAUTION:
ELECTRICAL
SHOCK HAZARD
DO NOT splash or pour water
onto control panel or wiring.
DO NOT submerge drawer
frames in water. Water
damage is not covered by
warranty.
IMPORTANT: DO NOT use
steel wool or abrasive
cleansers to clean the
warmer, drawers or drawer
rollers.
IMPORTANT:
Be careful to avoid damaging
thermometer or thermostat
bulbs, which are exposed
inside cavity.
046
p/n
3070
33
O
p
M
Tortilla Chip
W
a
rmer