Weed Eater 532 43 46-60 - Manual (Page 5)

5
PULL OUT ON STOP
BRACKET TO REMOVE
SUPPORT ASSEMBLY
TO REMOVE THE SUPPORT ASSEMBLY (See Fig. 2B)
1. Pull outward on the stop bracket enough to allow support
assembly to be lifted up and away from drawbar.
SHOULDER
BOLTS
SUPPORT
ASSEMBLY
REAR MOUNTING BRACKET
(See Fig. 2A and 2B)
NOTE: Your new drawbar already has four (4) shoulder bolts
installed. Simply hang the mounting bracket on the bolts.
REAR DRAWBAR
(See Fig. 1A, 1B)
2 1
Fig. 2A
Fig. 1A
Fig. 1B
Fig. 2B
1. Remove existing drawbar by removing four screws.
Insert flat screwdriver to remove bumper from engine
plate. Lift up and pull rearward.
2. Install new drawbar by replacing screws removed in
step 1.
ASSEMBLY
DRAWBAR
DRAWBAR
ENGINE PLATE