Williams Sound PPA T36 - Manual (Page 7)

® 7
w
idEBANd
FM R
ECEivERS
R
ECEivER
M
OdEL
PPA R35
The PPA R35 is a single-channel receiver operating on the 72-76 MHz bandwidth. It features
volume on/off control, power and low battery indicator, and an earphone jack (see FIG 5).
Instructions:
B
ATTERy
i
NSTALLATiON
Make sure there are two alkaline or rechargeable AA batteries in the receiver. If batteries are
not installed, see Battery Information on page 11.
NOTE: The ON indicator will illuminate RED to indicate low battery.
C
ONNECTiNG
E
ARPHONES ANd
H
EAdPHONES
Plug the earphone into the “Headphone/Earphone” jack on the top of the unit. Only mono-
phonic earphones and headphones will operate properly. If stereo headphones are used, sound
will be heard only in one side. Williams Sound evaluates each earphone and headphone used
with the PPA R35 receiver; we can only assure optimum performance when Williams Sound
earphones and headphones are used.
O
PERATiNG THE
R
ECEivER
NOTE: Check to make sure the T36 transmitter is on and transmitting audio. Also, make sure
the T36 is transmitting on the same frequency as the receiver. If the R35 receiver needs to be
re-tuned (most Williams Sound receivers are set at the factory at 75.7 MHz), see page 8 for
frequency change instructions.
Turn the receiver on by rotating the volume control knob clockwise. The receiver’s ON indi-
cator should illuminate green. Adjust the volume control for your comfort. To turn the receiv-
er off, rotate the volume control knob counter-clockwise until it clicks off. The receiver’s ON
indicator should not be lit.
To maximize battery life, remember to turn the receiver off when it’s not in use.
R35 Front
R35 Top
On/Off
Volume Switch
Headphone/Earphone
Jack
"On" Indicator
LED
R35 Front
R35 Top
On/Off
Volume Switch
Headphone/Earphone
Jack
"On" Indicator
LED
R35 Top
R35 Front
FiG 5: R35 v
iEwS