beautypg.com

Assembly, Operation, Attaching the shield warning – Weed Eater Twist N' Edge 530083927 User Manual

Page 3: Fueling engine, How to stop your unit, Warning, How to start your unit warning

background image

3

retor by starting the engine and letting it run

until it stops.

S

Store unit and fuel in an area where fuel va-

pors cannot reach sparks or open flames

from water heaters, electric motors or

switches, furnaces, etc.

S

Store unit so line limiter cannot accidentally

cause injury. Unit can be hung by the tube.

S

Store the unit out of the reach of children

SPECIAL NOTICE:

This unit is not

equipped with a temperature limiting muffler

and spark arresting screen which meets the re-

quirements of California Codes 4442 and 4443.

All U.S. forest land and the states of California,

Idaho, Maine, Minnesota, New Jersey, Ore-

gon, and Washington require by law that many

internal combustion engines to be equipped

with a spark arrestor screen. If you operate in

a locale where such regulations exist, you are

legally responsible for installing and maintain-

ing the operating condition of these parts. Fail-

ure to do so is a violation of the law. If a spark

arrestor is required in your area, contact your

Authorized Service Dealer for the proper kit.

SPECIAL NOTICE:

Exposure to vibrations

through prolonged use of gasoline powered

hand tools could cause blood vessel or nerve

damage in the fingers, hands, and joints of

people prone to circulation disorders or abnor-

mal swellings. Prolonged use in cold weather

has been linked to blood vessel damage in

otherwise healthy people. If symptoms occur

such as numbness, pain, loss of strength,

change in skin color or texture, or loss of feeling

in the fingers, hands, or joints, discontinue the

use of this tool and seek medical attention. An

anti-vibration system does not guarantee the

avoidance of these problems. Users who oper-

ate power tools on a continual and regular basis

must monitor closely their physical condition

and the condition of this tool.

ASSEMBLY

ATTACHING THE SHIELD

WARNING:

The shield helps to protect the

operator and others from thrown objects, and is

equipped with a line limiter blade which cuts ex-

cess line. This blade (on underside of shield) is

sharp and can cut you.
S

Remove wing nut from shield.

S

Insert bracket into slot as shown.

S

Pivot shield until bolt passes through hole

in bracket.

S

Securely tighten wing nut onto bolt.

Slot

Shield

Wing

Nut

Bracket

Line Limiter Blade

FUELING ENGINE

This engine is certified to operate on unleaded

gasoline. Gasoline must be mixed with a good

quality 2-cycle air-cooled engine oil designed

to be mixed at a ratio of 40:1. Poulan/Weed

Eater brand oil is recommended. (A 40:1 ratio is

obtained by mixing 3.2 ounces of oil with 1 gal-

lon of unleaded gasoline). When mixing fuel fol-

low the instructions printed on the container. Al-

ways read and follow the safety rules under

FUEL SAFETY.

OPERATION

For occasional use only.

HOW TO STOP YOUR UNIT

Push and hold engine stop switch in the

STOP

or

OFF

position until the unit has fully stopped.

WARNING:

The trimmer head will turn

while starting the engine. A hot muffler can

cause serious burns.

HOW TO START YOUR UNIT

WARNING:

The trimmer head will turn

while starting the engine. A hot muffler can

cause serious burns.

Starting Position

Knob

Primer Bulb

Trigger

This manual is related to the following products: