Wolf Downdraft Ventilation - Manual (Page 8)

Downdraft Care 8
Cleaning Recommendations
EXTERIOR SURFACES
Most exterior surfaces of your downdraft ventilation
system are stainless steel or aluminum. Although these
surfaces are resistant to most stains, they are not totally
impervious to damage. Salt and some cooking liquids may
pit and stain the surface. Remove these spills immediately.
IMPORTANT NOTE: Do not use steel wool pads or
abrasive cleaners; they will permanently scratch stainless
steel and aluminum surfaces.
Use a spray degreaser to remove fingerprints and greasy
spatters. Spray on a cloth and wipe the surface. Buff dry
immediately to avoid streaking. For hard water stains, use
white vinegar and water.
To clean, use a clean cloth or sponge and wipe exterior
surfaces with warm water and mild detergent. Rinse and
dry immediately.
Apply a protective polish to exterior surfaces to maintain
luster and protect from food stains. Use a soft, nonabra-
sive stainless steel cleaner like Signature polish and apply
with a soft lint-free cloth, always in the same direction as
the grain. To bring out the natural luster of stainless steel,
lightly wipe the surface with a water-dampened microfiber
cloth followed by a dry polishing chamois. Better results
are obtained by keeping the cloth in continuous contact
with the stainless steel.
Signature polish is available from Signature Limited
Laboratory, P. O. Box 13436, Dayton, Ohio 45413, or call
877-376-5474.
CONTROL MODULE
Use a spray degreaser to remove fingerprints and greasy
spatters. Spray on a cloth and wipe the surface. Do not
spray directly on the control module. Use a clean cloth or
sponge and wipe the surface with warm water and a mild
detergent. Rinse and dry immediately.
IMPORTANT NOTE: Be careful not to soak the control
module. Although they are sealed, excessive moisture may
cause damage to the controls.