Wilson Electronics 271245 - Manual (Page 6)

5
Installing a Wilson Amplifi er
Warning: Do not plug in the DC power
supply until the outside and inside antenna
cables are attached to the amplifi er.
!
Select a location to install the amplifi er that
is away from excessive heat, direct sunlight
or moisture and that has proper ventilation.
Recommended installation locations are:
• Under the seat
• Under the dash
Run the cable from the outside antenna and
attach it to the FME-Male connector labeled
“outside antenna” on the amplifi er.
Attach the inside antenna cable to the FME-
Male connector labeled “inside antenna” on
the amplifi er.