Wachsmuth & Krogmann RC-3 - Manual (Page 3)

2
IMPORTANT SAFEGUARDS
When using electrical appliances, especially when children are present, basic safety
precautions should always be followed to reduce the risk of fire, electric shock, and/or
injury to persons, including the following:
• READ AND SAVE ALL INSTRUCTIONS
• Do not touch hot surfaces. Use potholders when removing cover or handling hot
containers.
• To protect against electrical shock, do not immerse cord, plug or base unit in water
or other liquid.
• Close supervision is necessary when any appliance is used by or near children.
• Unplug from outlet when not in use. Allow to cool before cleaning.
• Do not operate appliance with a damaged cord or plug, or after the appliance
malfunction or has been damaged in any manner. Return appliance to an authorized
service facility for examination, repair or adjustment.
• The use of accessory attachments not recommended by this appliance manufacturer
may cause injury.
• Do not use outdoors.
• Do not let cord hang over edge of table or counter, or touch hot surfaces.
• Do not place on or near a hot gas or electric burner, or in a heated oven.
• Extreme caution must be used when moving an appliance containing hot food, water
or other hot liquids.
• Do not use appliance for other than intended use.
• Lift and open cover carefully to avoid scalding and allow water to drip into unit.
• Do not store any materials other than the manufacturer’s recommended accessories
in this unit when not in use.
This appliance is for HOUSEHOLD USE ONLY. It may be plugged into a standard
electrical outlet.
POWER SUPPLY CORD SAFETY TIPS
1. Never pull or yank on the supply cord or the appliance.
2. To insert plug, grasp it firmly and guide it into outlet.
3. To disconnect appliance, grasp plug and remove it from outlet.
4. Before each use, inspect the cord for cuts and/or abrasion marks. If any
are found, this indicates that the appliance should be serviced and the cord
replaced. Please return it to our Service Department or to an authorized
service representative.
5. Never wrap the cord tightly around the appliance, as this could place undue
stress on the cord where it enters the appliance and cause it to fray and
break.
DO NOT OPERATE APPLIANCE IF THE CORD SHOWS ANY DAMAGE OR IF
APPLIANCE WORKS INTERMITTENTLY OR STOPS WORKING ENTIRELY.
If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
SAVE THESE INSTRUCTIONS!