Whynter SNO T-2C/T-2CA - Manual (Page 9)

T-2 Version 08/05
9
Hints and Tips
Do not place the appliance on its side or upside down. Pay particular attention to this when
the appliance is being moved or transported.
Ventilation grilles must not be obstructed.
Do not immerse the appliance in water or other liquids.
The appliance has internal moving parts. Do not open the Window whilst it is connected to
the electricity supply and take particular care to prevent children from getting access to or
playing with the appliance. The ice making element gets very cold and touching them could
result in ice burns.
Do not use water below 46
o
F/8
o
C for filling as this may cause the ice cubes to fuse into one
large block of ice, particularly if medium (M) or large (L) ice cube size is selected. Always try
small (S) ice cube selection first as this may give cubes of sufficient size.
As with all electrical appliances if used outdoors ensure that it is protected from the elements
and use an earth leakage contact breaker for safety. Do not expose the appliance to rain and
do not use or store it where it could get damp or wet.
Do not put the appliance near sources of heat. In case of damage to the appliance or its lead
we advise not using it and to return it for authorized repair and parts replacement.
Using parts not recommended by the manufacturer can be dangerous. Only use the
appliance for its intended purpose, the production of ice cubes.
The refrigerant gas used in the appliance may be a chemical waste. Disposal of the
appliance must be done in a proper environmentally friendly way. Inquire about proper
disposal with your local waste processing department.