Whirlpool 2302309 - Manual (Page 14)

14
1. Press up on the dispenser paddle, as shown, to release.
2. Pull down on the dispenser paddle to remove.
3. Replace the dispenser paddle by firmly snapping it into the
dispenser cover as shown.
The Dispenser Light
The dispenser light turns on automatically when you press the
paddle to dispense water. If you want the light to be on
continuously, press the light bulb button, located on the left-hand
side of the dispenser control panel, for either ON or NIGHT LIGHT.
NOTE: The dispenser lights are LEDs which do not need to be
changed.
ON: Press the light bulb button once to turn on the dispenser
light. The green indicator will appear below ON.
NIGHT LIGHT: Press the light bulb button a second time to select
the night light mode. The green indicator will appear below NIGHT
LIGHT. The dispenser light will automatically adjust to become
brighter as the room brightens, dimmer as the room darkens.
OFF: Press the light bulb button a third time to turn the dispenser
light off.
The Dispenser Lock
The water dispenser can be locked for easy cleaning or to prevent
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the product, to
the ice maker, or to the dispenser light. It simply deactivates the
dispenser paddle.
To Lock the Dispenser:
Press and hold the LOCK OUT button for 2 seconds until the red
indicator appears. The water dispenser and the dispenser control
panel will not work.
To Unlock the Dispenser:
Press and hold the LOCK OUT button for 2 seconds until the
indicator disappears. Then continue to dispense water as usual.
Water Filtration System
NOTE: Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection before or
after the system. Systems certified for cyst reduction may be
used on disinfected waters that may contain filterable cysts.
Water Filter Status Light (on some models)
The water filter status light will help you know when to change
your water filter. The light will change from green to yellow. This
tells you that it is almost time to change the filter. It is
recommended that you replace the water filter when the status
light changes to red OR water flow to your water dispenser or ice
maker decreases noticeably.
After changing the water filter, reset the water filter status light.
The status light will change from red to green when the system is
reset.
Non-indicator Water Filter (on some models)
If your refrigerator does not have the status light, you should
change the water filter every 6 to 9 months depending upon your
usage. If the water flow to the water dispenser or ice maker
decreases noticeably before 6 months have passed, replace the
water filter more often.
Using the Dispenser Without the Water Filter
You can run the dispenser without a water filter. Your water will not
be filtered.
1. Remove the water filter.
2. Slide the cap off the end of the filter and replace the cap in the
base grille.
IMPORTANT: Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
3. Rotate the cap until it is securely in position.