Operation – Weed Eater 530086783 User Manual
Page 6
6
OPERATION
KNOW YOUR EDGER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR EDG-
ER ATTACHMENT. Compare the illustrations with your attachment to familiarize yourself with the
location of the various controls and adjustments. Save this manual for future reference.
Depth Adjustment Knob
Blade Shield
Gearbox
Wheel
Edger Blade
Tube
Hanger
Locking Lever
BLADE
The BLADE is designed to cut sod.
LOCKING LEVER
The LOCKING LEVER is used to prevent the
blade shaft from turning during blade replace-
ment.
DEPTH ADJUSTMENT KNOB
The DEPTH ADJUSTMENT KNOB is used
to adjust the wheel for blade cutting depth.
OPERATING THE COUPLER
Your powerhead is equipped with a coupler
which enables optional attachments to be
installed. The optional attachments are:
MODEL:
Cultivator
2000T
. . . . . . . . . . . . . . . . . . .
Blower
3000B
. . . . . . . . . . . . . . . . . . . . . .
Brushcutter
4000C
. . . . . . . . . . . . . . . . .
WARNING:
Always disconnect pow-
erhead spark plug (or disconnect powerhead
from power source) before removing or instal-
ling attachments.
REMOVING ATTACHMENT
CAUTION:
When removing or installing at-
tachments, place the powerhead and attach-
ment on a flat surface for stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
Knob
LOOSEN
TIGHTEN
Upper Tube
Lower
Attachment
2. Press and hold the locking/release button.
Locking/Release
Button
Coupler
Upper Tube
Lower Attachment
3. While securely holding the upper tube, pull
the attachment straight out of the coupler.
INSTALLING ATTACHMENT
1. Remove the tube cap from the attachment
(if present) and discard.
2. Position locking/release button of attach-
ment into guide recess of upper tube cou-
pler.
Coupler Primary Hole
Upper
Tube
Locking/
Release
Button
Attachment
Guide Recess
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.