Wells Bulit-In Electric Griddles - Manual (Page 6)

4
INSTALLATION INSTRUCTIONS
A. UNPACKING AND INSPECTION
1. Carefully remove the GRIDDLE from the carton. Remove all protective plastic film, packaging
materials and accessories from the GRIDDLE before connecting electrical power or otherwise
performing any installation procedures.
NOTE: DO NOT discard the CARTON and other PACKAGING MATERIAL until you have
inspected the warmer for hidden damage and tested it for PROPER OPERATION.
Refer to SHIPPING DAMAGE CLAIM PROCEDURE on page 1 of this manual.
2. Read all instructions in this manual carefully before starting installation of this griddle. READ AND
UNDERSTAND ALL LABELS AND DIAGRAMS ATTACHED TO THE GRIDDLE.
3. Carefully account for all components and accessories before discarding packing materials.
Store the accessories in a convenient place for later use:
B. INSTALLATION NOTES
1. Installation and start up of built-in griddles MUST be performed by an authorized installation company.
2. It is the RESPONSIBILITY OF THE INSTALLER to verify that this griddle installation is in
compliance with the specifications listed in this manual and on the specification sheet provided.
3. It is the RESPONSIBILITY OF THE INSTALLER to check with the AUTHORITY HAVING JURISDICTION,
in order to verify that this griddle installation is in compliance with local code requirements.
C. BUILT-IN GRIDDLES
1. This is a GENERAL GUIDE. For specific cutout dimensions and other installation details, refer to
the Installation Instructions supplied with the griddle.
2. Cutouts
a.
Cutout dimensions for griddle and control panels are listed on the Installation Instructions
provided with the griddle.
b. Verify griddle and control panel dimensions before making cutout.
c. Griddles must be installed in all-metal counters only.
3. Installation
a.
Verify that provided sealants are applied to the
underside of the top flange prior to setting the
unit into the cutout.
b. After installation, verify that the tabs on the
Wellsloks are turned out to lock the griddle into
the counter.
c. Apply a thin bead of food-grade silicone sealant
around the flange to seal it to the counter.
NOTE: Damage caused by leaks due to improper
installation is NOT covered by warranty.