Weslo WLEL28020 User Manual

Page 8

9. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may

be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical crosstrainer.

8. Apply a small amount of grease to the axle on the left

Disc Crossbar (16). Slide the Left Pedal Arm (11) onto
the axle. Slide an M10 Washer (35) onto an M10 x
25mm Patch Screw (22), and tighten the Patch Screw
into the axle.

Next, hold the lower end of the left Handlebar Arm (5)
inside of the bracket on the Left Pedal Arm (11). Apply
grease to a Pedal Arm Bolt Set (40). Attach the Left
Pedal Arm to the left Handlebar Arm with the Bolt Set.
Do not overtighten the Bolt Set; the Handlebar Arm
must pivot freely.

Attach the Right Pedal Arm (not shown) to the right
side of the elliptical crosstrainer in the same way.

Refer to step 5. Tighten the M10 x 66mm Button Bolts
(48) in the Upright (2).

Refer to step 6. Tighten the M8 x 38mm Button Bolts
(50) in the Handlebar Arms (5).

Grease