Waring CLEARICE WIM30 - Manual (Page 5)

4
5. Plug the unit into an electrical outlet and then press
power. A red Power On light and the blue light to indi-
cate medium cube size selection (default size) will come
on to indicate that the unit is ready to begin the ice
making cycle.
6. Press ‘Select’ to select the size of ice cube you desire:
small, medium or large. A blue light will indicate the size
selected.
7. The first cycle may take up to 14 minutes to complete,
depending on the starting temperature of the water.
To minimize the cycle time, always start with fresh
clean cold water.
Note: If starting water temperature is too warm it is
possible that the ice produced during the first cycle
will be smaller than the selected size. This function
is a normal consequence of the method required to
produce clear ice and applies to the first cycle only.
8. The Add Water Indicator will light when the water level
is low. The unit will automatically power off. To continue
producing ice, simply add more water. The unit will
automatically restart when the water level is sufficient
to produce ice. If no more ice is needed, press On/Off
to turn the unit off.
9. The Ice Full Indicator will light when the ice storage
basket is full. To continue operation, simply remove
some ice from the storage basket. The unit will
automatically restart approximately one minute after
ice is moved away from the sensor. If no more ice is
needed, press On/Off to turn the unit off.
10. Please keep the lid in the closed position while the ice
maker is running except to remove ice or add water.
Use included ice scoop to remove ice from storage
basket.