Weider WEBE37340 - Manual (Page 20)

18
38. Attach the Seat (10) to the Bench Frame (1) as
shown with four M6 x 16mm Screws (29).
40. Lubricate an M10 x 68mm Bolt (98) with grease.
Attach the Leg Lever (5) to the Bench Leg (4)
with the Bolt and an M10 Nylon Locknut (34). Do
not overtighten the Locknut; the Leg Lever
must be able to pivot easily.
41. Slide a Pad Tube (27) into the Bench Leg (4).
Slide two Foam Pads (26) onto the ends of the
Pad Tube.
Assemble two Pad Tubes (27) to the Leg Lever
(5) in the same manner.
39. Attach the Weight Tube (76) to the Leg Lever (5)
with an M8 x 58mm Bolt (75), two M8 Washers
(60), the 10mm Spacer (21), and an M8 Nylon
Locknut (17).
Press the 19mm Angled Outer Cap (61) onto the
indicated end of the Weight Tube (76).
38
10
29
29
1
39
40
41
5
61
60
76
75
21
60
17
5
5
27
4
27
27
26
26
34
4
98