Wasp Bar Code WPA206 - Manual (Page 2)

Steps for getting started
with your WPA206 mobile
device
1. Unpack
Open the box and remove all the pieces from
their protective packaging.
Parts included: WPA206 unit, a bag with
extra parts including an extra stylus, a power
cable, a power supply, a battery, a USB
cable, and at least one CD.
2. Remove the Protective Film
Remove the protective film from the LCD
display on the WPA206 unit and discard.
3. Open the Battery Compartment
Take the stylus out of the back of the unit
or from the extra parts bag. Pull off the tip
of the stylus to reveal a screwdriver.
Turn the WPA206 over and place it on a
solid flat surface. At the bottom of the back
of the unit there are two large screws
below the lock and unlock images.
Battery Door Screws
Gently turn both screws counterclockwise
with the screwdriver. They will only turn
one quarter turn, and then the screws will
pop up. When both screws have popped
up, use the strap to gently pull up on the
bottom of the door. The door is hinged to
the unit at the top of the compartment.
Take the door completely off.
Battery Door
Memory Expansion Slot Door
Battery Compartment
4. Install the Battery
Insert the rechargeable lithium ion battery
pack into the battery compartment. Make
sure the battery contacts on the battery
are aligned with and touch the contacts in
the battery compartment.
Battery Contacts
Replace the battery door and tighten the
screws with the screwdriver by pressing
down and then turning clockwise one
quarter turn.
Replace the tip of the stylus over the
screwdriver. The screwdriver should never
be used on the LCD display!
The unit may automatically power on when
the battery is placed in the unit.
Immediately turn the unit off by pressing
and holding the power button. See Step 6.