Weider WESY20000 - Manual (Page 9)

9
12. Attach the Backrest Rails (22) to the Backrest (13)
as indicated using four M6 x 16mm Screws (31).
Make sure the Backrest Rails are oriented exactly
as shown.
Attach the Backrest Bracket (23) to the Backrest
(13) using two M4 x 25mm Screws (57). When
attached, the Backrest Bracket should be flush with
the ends of the Backrest Rails (22).
With the Backrest (13) oriented as shown, slide the
Long Lock Pin (59) through the holes in the
Backrest Rails (22) and through the front holes in
the Seat Carriage (11).
12
13
Wide End
22
57
31
31
59
11
11. Attach the Leg Lever (10) to the Rail Leg (9) using
an M10 x 67mm Bolt (48) and an M10 Nylon
Locknut (42).
11
10
9
48
42
13. Place one end of the Long Cable (18) in a Pulley
Bracket (49). Secure one of the three Cable Pulleys
(50) to the Pulley Bracket using an M10 x 27mm
Bolt (51) and an M10 Nylon Locknut (42). Attach
the Pulley Bracket to the Left Brace (5) using an
Eyebolt (53) and an M8 Nylon Locknut (37).
Attach a Pulley Bracket (49) and a Cable Pulley
(50) to the opposite end of the Long Cable (18) and
attach it to the Right Brace (4) in the same manner.
13
18
51
49
49
50
53
53
51
50
42
42
5
37
4
23