Wachsmuth & Krogmann PCSD180T - Manual (Page 4)

2
3
4
5
Figure-7
Figure-8
GENERAL SAFETY RULES
WARNING! Read and understand all instructions. Failure to follow all
instructions listed below may result in electric shock, fire or serious personal
injury.
SAVE ALL INSTRUCTIONS!
WORK AREA
1. Keep your work area clean and well organized. Cluttered benches and dark
areas invite accidents.
2. Do not operate power tools in explosive atmosphere, such as in the
presence of flammable liquids, gases, or dust. Power tools create sparks
which may ignite the dust or fumes.
3. Keep bystanders, children and visitors away while operating a power tool.
Distractions can cause you to lose control.
ELECTRICAL SAFETY
1. Do not abuse the cord. Never use the cord to carry the tool. Keep cord away
from heat, oil, sharp edges or moving parts. Replace damaged cords
immediately. Damaged cords may create a risk of fire.
2. A battery operated tool with integral batteries or a separate pack must be
recharged only with the specified charger for the battery. A charger that may
be suitable for one type of battery may create a risk of fire when used with
another battery.
3. Use battery operated tool only with specifically designated battery pack.
Use of any other batteries may create a risk of fire. 6
PERSONAL SAFETY
1. Stay alert, watch what you are doing and use common sense when
operating a power tool. Do not use tool while tired or under the influence of
drugs, alcohol or medication. A moment of inattention while operating
power tools may result in serious personal injury.
2. Dress properly. Do not wear loose clothing or jewelry. Contain long hair.
Keep your hair, clothing and gloves away from moving parts. Wear
protective goggles when operating the machine. It is recommended to wear
protective goggles, gloves, sturdy non-slipping shoes and an apron.
3. Avoid accidental starting. Be sure switch is in OFF position before
installing battery pack. Carrying tools with your finger on the switch or
installing a battery pack when the switch is ON invites accidents. Do not
install the battery pack before carrying out any work on the machine.
4. Remove adjusting wrench before turning the tool on. A wrench or a key that
is left attached to a rotating part of the tool may result in personal injury.
5. Do not overreach. Keep proper footing and balance at all times. Proper
footing and balance enables better control of the tool in unexpected
5 6