Weider 831.150380 - Manual (Page 6)

1. Before beginning assembly, be sure that you
have read and understand the information in
the box above.
Set the Left and Right Base Sections (40, 47) on
the floor as shown. The indented holes must be
facing the floor. Insert two M8 x 48mm Carriage
Bolts (3) up through the indicated holes.
Press a 38mm x 50mm Inner Cap (16) into the
Lower Lat Tower (23). Slide the Lower Lat Tower
onto the two M8 x 48mm Carriage Bolts (3) in the
Base (40, 47). Insert two M8 x 68mm Bolts (8)
through the Lower Lat Tower and the Base.
Thread M8 Nylon Locknuts (7) onto all four Bolts.
Do not tighten the Nylon Locknuts yet.
2. Press two 38mm x 50mm Inner Caps (16) into the
Base (40). Insert four M8 x 48mm Carriage Bolts
(3) up through the Base.
1
16
40
8
7
7
7
47
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts of the WEIDER ® PRO 335 in a
cleared area and remove the packing materials;
do not dispose of the packing materials until
assembly is completed.
• Read each assembly step before you begin.
• For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART on the previous page. Note: Some
small parts may have been pre-attached for ship-
ping purposes. If a part is not in the parts bag,
check to see if it has been pre-attached.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the WEIDER ® PRO 335, make
sure that all parts are oriented as shown in the
drawings.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) standard screwdriver
• One (1) rubber mallet
• Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
6
The Indented Holes
must face the floor
2
40
16
16
3
3
3
23