Winegard SD - Manual (Page 7)

7
Connecting two receivers
1. Connect the gray coax cable coming from the
RoadTrip™ to the “SATELLITE IN” input on the
primary receiver. The primary receiver is the
receiver used most often and will toggle between
satellites.
2. Connect the white coax cable coming from the
RoadTrip™ to the “SATELLITE IN” input on the
secondary receiver. NOTE: Secondary receiver
will not toggle.
3. See page 5 of Operations Manual for receiver
set-up.
Installation • Wiring • Specifications
Connecting one receiver
1. Connect the coax cable from the gray coax
cable of the RoadTrip™ to the “SATELLITE IN” on
the receiver.
2. See page 5 of Operations Manual for receiver
set-up.
Connecting the receiver —
Your RoadTrip™ has now been success-
fully installed. Proceed to the Operation
Manual for RoadTrip™ setup and for Op-
eration Instructions.
Features and specifications
• One button operation.
• Dual receiver capable.
• Depending on receiver type, you can access
satellites 119°, 110°, or 101°.
• No user input required.
• Elevation range 20° to 60°;
azimuth +360° (0-720°)
• Dome UV protected.
• Specifications for max amperage 5.0A
• Specifications for unit operatating voltage. -10.5 - 13.8V
• Specifications for supply voltage. 12 - 13.8V
• Compact size —
32” diameter, 12-1/2” height
Shipping size - 37-1/4” x 34” x 14-3/4”
Shipping weight - 55 lbs.
• Operating temperature
-13°F to +140°F