Weslo WLTL39112 - Manual (Page 8)

BATTERY INSTALLATION
The console requires two "AA" batteries (not in-
cluded). Alkaline batteries are recommended. Open
the battery cover as shown in the drawing at the upper
right. Insert two batteries into the console, making sure
that the negative (–) ends of the batteries are touching
the springs in the console.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
inset drawing. Make sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.)
Stand on the foot grips of
the treadmill. Find the clip
attached to the key and
slide the clip onto the waist-
band of your clothing. Next,
insert the key into the con-
sole. Test the clip by carefully taking a few steps
backward until the key is pulled from the console.
If the key is not pulled from the console, adjust the
position of the clip as needed.
CAUTION:
Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing at
the lower right) while using the treadmill.
When the key is removed from the console,
the walking belt will stop.
• Adjust the speed in small increments.
• The training zones marked beside the
speed control are general guidelines only.
See page 14 for more information.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
Battery
Cover
Tab
CONSOLE DIAGRAM
Note: If there is a thin sheet of clear plastic
on the face of the console, remove it before
operating the console.
Clip
Batteries
8