Weslo DX3 - Manual (Page 8)

DIAGRAM OF THE CONSOLE
8
Clip
Key
Speed Control Water Bottle
Holder
(Water bottle
is not included)
Monitor Display
STEP BY STEP CONSOLE OPERATION
Before the console can be operated, two ÒAAÓ
batteries must be installed (see assembly step 6 on
page 6). Follow the steps below to operate the console.
Step onto the grip tape on the treadmill. Find the clip
attached to the key (see the drawing above), and slide
the clip onto the waistband of your clothing.
Follow the steps at the right and on page 9 to operate
the console.
Insert the key fully into the power switch.
Note: Inserting the key
will not turn on the dis-
play. The display will
turn on when the
ON/RESET button is
pressed or when the
walking belt is started.
(If you just installed
batteries, the display will already be on.)
1
CAUTION:
Before operating the
console, read the following precautions.
¥ Do not stand on the walking belt when turning
on the power.
¥ Always wear the clip (see the drawing above)
while operating the treadmill. When the key is
removed from the console, the walking belt will
stop.
¥ Adjust the speed in small increments.
¥ To reduce the possibility of electric shock, keep
the console dry. Avoid spilling liquids on the
console and use only a sealable water bottle.