Whistler 800 WATT POWER INVERTER - Manual (Page 11)

OPERATION SUMMARY
19
OPERATION SUMMARY
18
• This inverter is designed to be connected to the power
source with the supplied cables or with #4 wire up to
12’ - #2 wire for longer length. When utilizing the sup-
plied cables do not attempt to modify or lengthen
them.
• Always make certain that the power cable terminal con-
nections run Negative (-) to Negative (-) and Positive (+)
to Positive (+). Check these connections frequently to
ensure that they are secure.
• Make certain the rated power consumption of the appli-
ance or equipment you wish to operate is compatible with
the capacity of your inverter.
• If the rated power consumption of the equipment is in the
range of the maximum specified wattage of your convert-
er, test the inverter to ensure that it will operate properly.
• This inverter is not designed to operate heat generating
appliances such as coffee makers, irons, hair dryers,
toasters and heaters.
• Before attempting to use a battery charger see page 11.
• Before attempting to use medical equipment see page 4.
• Use only fuses which conform with the design specifica-
tions outlined in this manual.
• When operating the inverter with the engine off, start the
engine every hour and let it run for at least 10 minutes to
recharge the battery.
• In the event of automatic shut down, turn the inverter OFF
(O) immediately. Do not restart the inverter until the
source of the problem has been identified and corrected.
• To avoid battery drain always disconnect the inverter
when not in use.
• Do not expose the inverter to moisture.
• Avoid placing the inverter near sources of heat or in
direct sunlight.
• When in use, make certain that the inverter is properly
ventilated.
• Do not use the inverter near flammable materials,
fumes, or gases.
• Always operate the inverter in accordance with the
instructions in this manual. Failure to do so may result
in property damage, personal injury, or loss of life.