Wachsmuth & Krogmann MW5798 - Manual (Page 8)

- 7 -
DEEP CONDITIONING MODE
This mode can rescue rechargeable batteries damaged by
memory effect. It will automatically discharge and recharge the
batteries in both compartments three times.
1. Insert batteries into either one or both of the compartments.
Please note that this mode will automatically discharge and
recharge the batteries in both compartments three times.
2. Press and hold the yellow DISCHARGE button until the
READY LEDs begin to flash and the charger makes “beep”
sound. Release the button immediately.
3. The LEDs light up as in Discharge and Charge Mode. The
only difference is the flashing of the READY LEDs. During the
1st cycle, the READY LEDs flash three times, stop, and
repeat until the cycle is completed.
4. During the 2nd cycle, the READY LEDs flash twice, stop, and
repeat until the cycle is completed.
5. During the final cycle, the READY LEDs flash once, stop, and
repeat until the whole deep conditioning mode is completed.
6. When this mode is completed, the READY LEDs blinks, and
the CHARGE and DISCHARGE LEDs all go off. The batteries
are now ready for use.
Note: Press the DISCHARGE button to cancel Deep
Conditioning Mode and switch back to Charge Mode at any
time if desired.
Note: The deep conditioning process from beginning to end
may take up to 20 - 40 hours. Please see the charge and
discharge equations on page 4 to estimate approximate time.