Westinghouse LTV-27w6 HD - Manual (Page 17)

3
INSTALLATION
15
English
4. Connect power cable and power on the High Definition LCD TV
Connect the power cord to the High Definition LCD TV then to a properly grounded AC
outlet and press power to turn on the High Definition LCD TV.
NOTE: The High Definition LCD TV will take a few seconds to power up.
5. Turn on your computer
The High Definition LCD TV will auto adjust to the resolution of the computer.
6. Turn on the cable box or satellite receiver
If using DVI or HDMI connection, the cable box or satellite receiver will need to be
restarted to complete HDCP authentication to view the picture.
7. Select an input source for the High Definition LCD TV using the OSD
menu or remote control
8. If connecting to an Antenna, Cable or other RF source, run Autoscan
to receive all available channels:
1. Press the ‘Menu’ key on the remote or side panel and use the left/right arrow keys
to select the TV menu.
2. Use the up/down arrow keys to select “Tuner Source”.
3. Use the arrow keys to select your signal source “Air/Cable/IRC/HRC”.
4. After selecting your signal source, use the up/down arrow keys to select “Auto
Scan”. Press “Enter” to start scanning for channels.
5. This will take a few minutes to identify analog and digital channels.
9. If connecting to a computer:
For the best picture quality, set PC timing mode to VESA* 1366x768 at 60Hz. Refer to
your computer’s graphic card user guide for questions on how to set this timing mode.
Many computers show 1360x768 as an alternative resolution.
* VESA is a trademark of Video Electronics Standards Association. All other trademarks
are the property of their respective owners.