Westinghouse LCM-17W7 - Manual (Page 8)

7
Front Control Panel and Rear Side Connectors
1. “-“ and “+” Buttons When the OSD Menu is displayed:
Increase/Decrease Volume (While in the Volume Menu)
When the OSD Menu is not displayed:
Increase/Decrease Volume
2. MENU Button Enter/Exit the OSD Menu
3. LED Display The LED is lit green when in the monitor is in use and orange when
in power-saving mode.
4. and Buttons When the OSD Menu is displayed:
Highlight a menu option or adjust the value of a selected option
When the OSD Menu is not displayed:
Adjust the backlight brightness
5.INPUT/OK Button When the OSD Menu is displayed:
Select a menu option
When the OSD Menu is not displayed:
Switch the signal input between analog and digital
6. Power Button Power On/Off
7. AC Power Connector Use the AC power cord to connect the monitor to a grounded AC
outlet.
8. Audio In Use the 3.5mm audio cable to connect to your PC Audio Output.
9. Digital DVI-D Connector Use a DVI-D cable (not included) to connect to a computer with a
DVI-compatible output terminal (DVI-D: 24 pins) with WXGA
output capability.
10. Analog VGA Connector Use an analog VGA cable (not included) to connect to your
PC VGA Output.
11. Ventilation Openings Note: Do not block the ventilation openings. This may cause the
monitor to overheat or malfunction.
12. Security Lock Anchor Secure the LCD monitor by using a Kensington Micro Saver Security
Lock.