Whistler PRO-3600 - Manual (Page 13)

23 24
How to install the Console Cradle
1. Copy cut-out template.
2. Carefully remove section marked “CUTOUT”.
3. Tape template to desired vehicle mounting location.
4. Trace cutout area.
5. Carefully cut/remove dashboard or vehicle material.
6. Trim “hole” to ensure snug fit of cradle.
7. Insert M4.0x20 mm bolt into cradle.
8. Insert M4.0 nut into Clasp.
9. Place Clasp behind dashboard hole, insert cradle
and start to tighten bolt.
10. Ensure all 4 clasp “legs” engage with notches on
rear of cradle.
THROUGH DASH BRACKET THROUGH DASH BRACKET