Weslo WLEX27180 - Manual (Page 6)

6
29
1
2
1
1. Loosen the Frame Knob (29) on the right side of the
Frame (1). Slide the Seat Frame (2) out until it
stops. Tighten the Frame Knob.
2. Run the Reed Switch Wire Extension (62) down
through the Handlebar Post (3) and plug it into the
Reed Switch Wire (42). Push the Resistance Cable
(61) up through the Handlebar Post. Attach the
Handlebar Post (3) to the Frame (1) with three M8 x
15mm Button Screws (53) and three M8 x 19mm
Washers (54). Be careful not to pinch the Reed
Switch Wire and its Extension (42,62) or the
Resistance Cable (61).
2
3
1
54
54
53
53
61
62
42
3
4
3
62
61
33
59
31
43
43
33
3. Plug the Reed Switch Wire Extension (62) into the
outlet on the back of the Console (33). Push the
Resistance Control (31) into its socket in the
Console. Next, attach the Console (33) to the
Handlebar Post (3) with four #8 x 1/2Ó Screws (43).
Next, connect the short cable on the Resistance
Control (31) to the Resistance Cable (61) as follows:
¥ Insert the tip of the short cable into the wire clip as
shown in drawing A.
¥ Firmly pull the short cable and slide it into the
metal bracket as shown in drawings B and C.
Make sure that the tip of the short cable is held by
the wire clip as shown.
3. The Console (33) requires two ÒAAÓ batteries (not
included)Ñalkaline batteries are recommended.
Remove the Battery Cover (59) on the top of the
Console. Refer to the inset drawing. Press two bat-
teries into the Console top. Make sure that the
negative (Ð) ends of the batteries are touching
the springs. Reattach the Battery Cover.
53
Batteries
Console Top
A
B C
Wire
Clip