Weider WEBE44490 - Manual (Page 8)

8
5. Insert two M10 x 68mm Bolts (34) into a Crossbar
Support Plate (59). Next, insert the Bolts into the indi-
cated holes in the Crossbar (20).
Slide the bracket on the Bench Frame (5) onto the
two M10 x 68mm Bolts (34) in the Crossbar (20).
Attach the Bench Frame with two M10 Nylon
Locknuts (11).
Tighten all M10 Nylon Locknuts used in steps 1
through 5.
5
34
59
20
11
5
6. Press three 2” Square Inner Caps (17) into the Leg
Lever (18).
Attach the Weight Tube (39) to the Leg Lever (18)
with an M8 x 64mm Bolt (43), two M8 Washers (23),
the Leg Lever Spacer (50), and an M8 Nylon Locknut
(13).
6
17
18
17
17
13
50
23
43
39
7. Press the Angle Cap (49) onto the indicated end of
the Weight Tube (39). Press a 1” Round Inner Cap
(12) into the opposite end of the Weight Tube.
Lubricate an M10 x 75mm Bolt (60). Attach the Leg
Lever (18) to the bracket on the Front Leg (19) with
the Bolt and an M10 Nylon Locknut (11).
Do not
overtighten the Nylon Locknut. You must be able
to freely pivot the Leg Lever.
7
19
18
12
39
11
49
Lubricate
60
4. Insert an M10 x 68mm Bolt (34) through the upper
hole in the Front Leg (19) and the bracket on the
Bench Frame (5). Insert another M10 x 68mm Bolt
through an M10 Washer (6), the lower hole in the
Front Leg, and the bracket on the Bench Frame.
Insert the Curl Post (42) into the Front Leg (19).
Secure the M10 x 68mm Bolts (34) with two M10
Nylon Locknuts (11).
Do not tighten the Nylon
Locknuts yet. The Curl Post (42) must slide freely
after assembly.
Set the Curl Post (42) aside until assembly step 17.
4
19
34
6
11
42
11
5