weber Summit 56219 User Manual

Page 23

WWW.WEbER.com

PRobLEm

cHEcK

SoLUTIoN

side burner does not light.

Is gas supply off?

The excess flow safety device, which is part of the barbecue to
cylinder connection, may have activated .

Turn supply on .

To reset the excess flow safety device turn all burner control
knobs and the cylinder valve off . Disconnect the regulator from the
cylinder . Turn burner control knobs to START/HI . Wait at least 1
minute . Turn burner control knobs to OFF . Reconnect the regulator
to the cylinder . Turn cylinder valve on slowly . Refer to “SIDE
BURNER IGNITION” .

flame is low in hi position.

Is the fuel hose bent or kinked?

Straighten hose .

push button ignition does not work.

Does burner light with a match?

If match lights burner, check igniter (See “SIDE BURNER
MAINTENANCE”) .

if problems cannot be corrected by using these methods, please contact the Customer service representative in your area using the contact information on our
web site. log onto www.weber.com

SIDE bURNER TRoUbLESHooTING

GRILL oUT™ HANDLE LIGHT TRoUbLESHooTING

PRobLEm

cHEcK

SoLUTIoN

weber Grill out™ handle light
does not light.

Are the batteries old?

Replace batteries .

Are the batteries installed correctly?

Refer to assembly illustration .

Is the lid in the up position with the power button ON?

Light will activate when lid is open .

Is the Weber Grill Out™ Handle Light activated?

Press the power button .

Is the Weber Grill Out™ Handle Light positioned correctly on the
handle?

Adjust position (refer to assembly illustration).

if problems cannot be corrected by using these methods, please contact the Customer service representative in your area using the contact information on our
web site. log onto www.weber.com