beautypg.com

Safety rules, Fueling, Starting – Weed Eater BARRACUDA 530087724 User Manual

Page 5

background image

-- 5 --

gutters, screens, patios, grills, porches,

and gardens.

D

Watch out for children, pets, open win-

dows, or freshly washed cars. Blow debris

away safely.

D

Use the full blower nozzle extension so the

air stream can work close to the ground.

D

After using blowers and other equipment,

CLEAN UP! Dispose of debris in trash re-

ceptacles.

SAFETY RULES

FUELING

This engine is certified to operate on un-

leaded gasoline. Gasoline must be mixed

with a good quality 2-cycle air-cooled engine

oil designed to be mixed at a ratio of 40:1.

Poulan/Weed Eater brand oil is recom-

mended. (A 40:1 ratio is obtained by mixing

3.2 ounces of oil with 1 gallon of unleaded

gasoline). When mixing fuel follow the

instructions printed on the container. Always

read and follow safety rules under HANDLE

FUEL WITH CAUTION in the SAFETY

RULES section.

SAFETY RULES

STARTING

TO STOP THE ENGINE:

D

To stop engine, move switch to

STOP

.

BEFORE STARTING THE ENGINE:

D

Fuel the engine. Move at least 10 feet (3

meters) away from the fueling site.

D

Hold the unit in the starting position as

shown. Make sure the blower end is di-

rected away from people, animals, glass,

and solid objects.

STARTING POSITION

BLOWER

VACUUM

WARNING:

When starting engine,

hold the unit as illustrated. Do not set unit on

any surface except a clean, hard area when

starting engine or while engine is running.

Debris such as gravel, sand, dust, grass,

etc. could be picked up by the air intake and

thrown out through the discharge opening,

damaging the unit or property, or causing se-

rious injury to bystanders or the operator.

Throttle

Trigger

Switch

Choke Lever

(shown in

HALF CHOKE

position)

Throttle

Lock

STARTING A COLD ENGINE (or a

warm engine after running out of

fuel):

D

Move switch to the

ON

position.

D

Activate the throttle lock as follows:

D

squeeze and hold throttle trigger;

D

press and hold throttle lock, then

D

release the throttle trigger

D

Move choke to

FULL CHOKE

position.

D

Pull starter rope handle sharply until en-

gine attempts to run, but

NO MORE THAN 6

PULLS.

LISTEN:

The engine may sound as if it is

trying to start before the 6th pull. This

sound may be hard to hear. If so, go to the

next step immediately.

D

Move choke to

HALF CHOKE

position.

D

Pull starter rope handle sharply until en-

gine runs, but no more than 6 pulls.

NOTE:

If engine has not started after 6

pulls, repeat all of the above steps.

D

Allow engine to run for 10 to 15 seconds,

then move choke to

OFF CHOKE

position.

D

Squeeze and release the throttle trigger to

release the throttle lock.

NOTE:

If engine dies with choke at

OFF

CHOKE

position, move the choke to the

HALF

CHOKE

position and pull the starter rope han-

dle 5 more times. If engine does not start and

operate properly, refer to

CARBURETOR AD-

JUSTMENTS.

D

To stop engine, move switch to

STOP

.

STARTING A WARM ENGINE:

D

Move switch to the

ON

position.

D

Move choke to

HALF CHOKE

position.

D

Activate the throttle lock.

D

Pull starter rope handle sharply until en-

gine runs, but no more than 6 pulls.

D

Move choke to

OFF CHOKE

position. Then,

squeeze and release the throttle trigger to

release the throttle lock.

NOTE:

If engine does not run after 5 pulls, it

is probably flooded. Wait a few minutes and

repeat procedure with choke at

OFF CHOKE

.

D

To stop engine, move switch to

STOP

.