Wayne-Dalton 3966 - Manual (Page 2)

NOTE: IF, AT ANY TIME, AN ERROR WAS MADE IN ENTERING THE CODES, SIMPLY PRESS AND
HOLD BOTH THE "7/8" AND "9/0" BUTTONS FOR 2 SECONDS TO RESET THE KEYLESS ENTRY.
REPEAT THE ABOVE PROCEDURES.
Note: One 3966 Keyless Entry can be programmed to open multiple garage door openers. To program
for additional openers, repeat steps A thru D above except input a different five digit PIN number for each
additional opener.
A. With new installations, it is recommended that the keyless entry be programmed
before mounting to wall, otherwise proceed to step B.
B. Unit should be programmed with garage door in the down position. For the iDrive
openers, pull the emergency disconnect handle to the manual operated position (lower
position).
C. Press the program button on the garage door opener to switch the opener to the
transmitter learn mode (see illustrations above). Opener will remain in the learn mode
for at least 30 seconds.
D. Press the desired five digit PIN (PERSONAL IDENTIFICATION NUMBER) number,
(example: 1-2-3-4-5). Garage door opener should beep or lamp should blink. For the
iDrive openers, return the emergency disconnect handle to the motor operated
position (upper position). Wait 5 seconds and press any button; the door should
move. Programming is now complete.
Programming or Changing Personal Identification Number START HERE
Always keep moving door in sight and
away from people and objects until it is
completely closed. NO ONE SHOULD
CROSS THE PATH OF THE MOVING
DOOR.
Never let children operate or play with
door controls. Keep all controls away
from children.
To comply with FCC rules, adjustment or
modification of transmitter is prohibited.
THERE ARE NO USER SERVICEABLE
PARTS EXCEPT FOR BATTERY
REPLACEMENT.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
WARNING
FCC WARNING
Before your Wireless Keypad will be able
to operate the opener, there are several
programming steps that have to be
completed.
PLEASE READ ALL INSTRUCTIONS
THOROUGHLY TO FAMILIARIZE
YOURSELF WITH THE PROGRAMMING
PROCEDURE BEFORE BEGINNING.
SAVE THESE INSTRUCTIONS FOR
REFERENCE WHENEVER YOU WISH
TO CHANGE YOUR PERSONAL
IDENTIFICATION NUMBER (PIN)
program button
Torsion
dr ve
program button
dr ve DoorMaster
program button
ClassicDrive
program button
Quantum