Weider WEBE09100 - Manual (Page 7)

5. Lubricate an M10 x 180mm Bolt (22). Attach the
Backrest Frame (27) to the Bench Frame (5) using
the Bolt, two M10 Washers (6), and an M10 Nylon
Locknut (11). Slide the Backrest Bracket (39) into
the indicated slot on the Bench Frame.
Do not
overtighten the Nylon Locknut; the Backrest
must be able to pivot freely.
To adjust the position of the Backrest, pull the
Backrest Knob (29) outward and move the Backrest
up or down. Slowly release the Backrest Knob,
making sure that the pin on the Backrest Knob is
inserted through one of the holes in the Backrest
Bracket (39).
5
7
3. Press four 25mm x 51mm Inner Caps (28) into the
ends of the Backrest Frame (27). Attach the
Backrest Bracket (34) to the Backrest Frame using
two M10 x 22mm Bolts (7) and two M10 Nylon
Locknuts (11).
3
27
34
11
28 7
28
6. Attach the Seat (14) to the Bench Frame (5) with
four M6 x 16mm Screws (3).
Make sure that the
Seat is turned as shown.
6
39
15
22
6
6 5
11
27
29
14
3
5
4. Attach the Backrest (15) to the Backrest Frame (27)
with four M6 x 64mm Screws (4) and four M6
Washers (30).
Make sure that the Backrest is
turned as shown.
15
Wide
End
Wide
End
30
30
4
4
4
27