beautypg.com

Weed Eater FeatherLite 530163077 User Manual

Page 5

background image

5

Engine

ON/STOP

Switch

Choke Lever

FULL

HALF

OFF

HOW TO START YOUR UNIT

WARNING:

The trimmer head will

turn while starting the engine. Avoid any con-

tact with the muffler. A hot muffler can cause

serious burns.

STARTING A COLD ENGINE (or a

warm engine after running out of

fuel)

Starting Position

1. Set unit on a flat surface.

2. Slowly press the primer bulb 6 times.

3. Move choke lever to the FULL CHOKE posi-

tion.

4. Squeeze the throttle trigger fully and hold

through all remaining steps.

Choke

Lever

Primer Bulb

Starter Handle

Muffler

5. Pull starter rope handle sharply until engine

sounds as if it is trying to start, but do not pull

rope more than 6 times.

6. As soon as engine sounds as if it is trying to

start, move choke lever to HALF CHOKE

position.

7. Pull starter rope sharply until engine runs,

but no more than 6 pulls.

NOTE:

If the engine doesn’t start after 6

pulls (at the HALF CHOKE position),

move the choke lever to the FULL CHOKE

position and press the primer bulb 6 times.

Squeeze and hold the throttle trigger and

pull the starter rope 2 more times. Move

the choke lever to the HALF CHOKE posi-

tion and pull the starter rope until the en-

gine runs, but no more than 6 pulls. If the

engine still doesn’t start, it is probably

flooded. Proceed to STARTING A

FLOODED ENGINE.

8. Once the engine starts, allow it to run 10

seconds, then move the choke lever to the

OFF CHOKE position. Allow the unit to run

for 30 more seconds at OFF CHOKE be-

fore releasing the throttle trigger.

NOTE:

If engine dies with the choke lever

in the OFF CHOKE position, move the

choke lever to the HALF CHOKE position

and pull the rope until engine runs, but no

more than 6 pulls.

STARTING A WARM ENGINE

1. Move the choke lever to the HALF CHOKE

position.

2. Squeeze and hold the throttle trigger. Keep

throttle trigger fully squeezed until the engine

runs smoothly.

3. Pull starter rope sharply until engine runs,

but no more than 5 pulls.

4. Allow engine to run 15 seconds, then move

the choke lever to OFF CHOKE.

NOTE:

If engine has not started, pull starter

rope 5 more pulls. If engine still does not run, it

is probably flooded.

STARTING A FLOODED ENGINE

Flooded engines can be started by placing

the choke lever in the OFF CHOKE position;

then, pull the rope to clear the engine of ex-

cess fuel. This could require pulling the starter

handle many times depending on how badly

the unit is flooded.

If the unit still doesn’t start, refer to

TROUBLESHOOTING

TABLE

or

call

1-800-554-6723.

OPERATING INSTRUCTIONS

It is recommended that the engine not be

operated for longer than 1 minute at full

throttle.

OPERATING POSITION

Eye Protection

Long Pants

Heavy Shoes

ALWAYS WEAR:

Cut from your right to your left.

WARNING:

Always wear eye protec-

tion. Never lean over the trimmer head.

Rocks or debris can ricochet or be thrown into

eyes and face and cause blindness or other

serious injury.
Do not run the engine at a higher speed than

necessary. The cutting line will cut efficiently

when the engine is run at less than full throttle.

At lower speeds, there is less engine noise and

vibration. The cutting line will last longer and will

be less likely to “weld” onto the spool.
Always release the throttle trigger and allow the

engine to return to idle speed when not cutting.

This manual is related to the following products: