Using your food processor, Assembling your attachments, Using your mini bowl – Wolfgang Puck BFPR0007 User Manual
Page 8
13
14
Using Your Food Processor
Important: If the processing bowl and cover are not correctly
assembled, the Food Processor will not function.
1
Plug the power cord into a 120V AC power.
2
Using the On/Off button on the control panel, press once to start
processing. The Pulse function remains on as long as the Pulse
button is pressed down. Further ingredients can also be added while
processing by pouring through the feed tube once the food pusher
has been removed.
3
After you have completed processing, press the On/Off button to
stop processing.
Note: For maximum control load the feed tube first before turning on
your food processor. Always use the food pusher for more evenly
processed foods and never use your fingers.
Important: The Food Processor is fitted with a safety thermal cut-out
device and will shut off in the event of overload. If this occurs, press the
Off button to turn the power off and unplug the food processor from
the wall outlet. Wait 15 minutes and then restart.
Assembling Your Attachments
Reversible Grating, Shaving
and Shredding Blades
1
Fit the processor bowl and Spindle as
detailed previously, in figures 1, 2 and 4.
2
Select the ‘Reversible’ disc of your choice
- Shredding (fine or coarse), Grating or
Shaving, and fit over the Spindle. See
figure 6.
Warning: Use caution as the blades are sharp.
4
Fit the processing cover to the processing
bowl as previously shown in figure 3 and
place the food pusher in the feed tube.
5
Plug the power cord into a 120V AC
power outlet.
6
Start processing using the On/Off or
Pulse buttons.
7
When processing is complete, remove the
disc and Spindle from the processing bowl
before removing the processed food.
figure 6
figure 7
continued
Using Your Mini Bowl
(Optional Accessory - Sold Separately)
1
Fit the processor bowl and Spindle as detailed previously,
in figures 1, 2 and 4.
2
Place the Mini Bowl over the Spindle of the Food Processor
3
Place the Mini Processing blade over the center shaft of the Mini
Processing bowl.
4
Fit the processing cover to the processing bowl as previously shown
in figure 3 and place the food pusher in the feed tube.
5
Plug the power cord into a 120V AC power outlet.
6
Start processing using the On/Off or Pulse buttons.
7
When processing is complete, remove the Mini Processing blade
from the mini bowl before removing the processed food.
Note: You can store your ingredients in the Mini Bowl by placing the Mini
Bowl lid over the bowl and pressing the center of the lid until it snaps
into place. The lid of the mini bowl will not snap into place unless the
mini blade has been removed.
Variable Slicing Blade
1
Fit the processor bowl and Spindle as detailed previously in figures
1, 2 and 4.
2
Fit the slicing disc over the Spindle, see figure 7.
Warning: Use caution as the blades are sharp.
3
The Slicing blade will adjust from 0 - 7mm in thickness. To adjust
the Slicing Blade, hold the blade by grasping the finger hole and
turn the center Spindle to the desired thickness. See figure 2.
4
Fit the processing cover to the processing bowl as previously shown
in figure 3 and place the food pusher in the feed tube.
5
Plug the power cord into 120V AC power outlet.
6
Start processing using the On/Off or Pulse buttons.
When processing is complete, remove the disc and Spindle from the
processing bowl before removing the processed food.
HSN_7CupFoodProcManual 4/20/09 10:50 AM Page 13