Weider 831.159830 - Manual (Page 21)

21
53. Wrap the Press Cable (72) around a 3 1/2” Pulley
(35) in the direction shown. Attach the Pulley and
a Cable Trap (38) to the indicated hole on the
right side of the Press Upright (5) with a 3/8” x 4
3/4” Bolt (102) and a 3/8” Nylon Jamnut (92).
Note: Thread the Jamnut only two turns onto
the Bolt; another Pulley will be attached to the
Bolt in step 57. Make sure the Cable Trap is
positioned to hold the Cable in the groove of
the Pulley.
53
38
35
5
102
72
92
54. Route the Press Cable (72) through the Press
Frame (17) and around a 3 1/2” Pulley (35) as
shown. Attach the Pulley and a Cable Trap (38) to
the indicated hole on the right side of the Leg
Press Lever (14) with a 3/8” x 4 3/4” Bolt (102)
and a 3/8” Nylon Jamnut (92). Note: Thread the
Jamnut only two turns onto the Bolt; another
Pulley will be attached to the Bolt in step 56.
Make sure the Cable Trap is positioned to hold
the Cable in the groove of the Pulley.
55. Wrap the Press Cable (72) around a “V”-Pulley
(34) in the direction shown. Attach the Pulley and
a Long Cable Trap (37) underneath the Press
Seat Frame (12) with a 3/8” x 4 1/4” Bolt (85), a
3/8” Washer (97), and a 3/8” Nylon Locknut (90).
Note: the Press Seat Frame has five adjust-
ment holes. Attach the Pulley to the second
hole from the Leg Press Lever (14). Make sure
the Cable Trap is positioned to hold the Cable
in the groove of the Pulley.
56. Remove the 3/8” Nylon Jamnut (92) used in step
54.
Wrap the Press Cable (72) around a 3 1/2” Pulley
(35) in the direction shown. Slide a Cable Trap
(38) and the Pulley onto the 3/8” x 4 3/4” Bolt
(102) in the Leg Press Lever (14). Properly tight-
en the 3/8” Nylon Jamnut (92) onto the Bolt.
Make sure the Cable Trap is positioned to
hold the Cable in the groove of the Pulley.
54
55
56
97
72
38
38
35
92 72
85
102
34
90
14
12
14
102 72
38
92
14
35