Well Traveled Living Stowe - Manual (Page 5)

3. Turn the fireplace so you are facing the back of the fireplace.
4. Look for the access plate with the gold printing on it.
5. Remove the 3 screws holding the access plate in position (FIG1). Once you have
removed the 3 screws, lift the access plate so the 2 positioning tabs come free of
their slots. Once you have removed the access plate you can see and access the two
40 watt chandelier bulbs (FIG 2).
6. Remove each light bulb by unscrewing them out of the bases, turning them
counterclockwise. You can use one hand to hold the light socket in place, if required.
7. Install the new light bulbs by turning each light bulb into the base clockwise. You can
use one hand to hold the light socket in place, if required.
8. Replace the access plate by inserting the 2 tabs, pushing the plate up against the
fireplace back, and inserting the 3 screws.
9. Turn the fireplace back so you are facing the front of the fireplace.
10. Plug the fireplace back into the electrical outlet and turn the power on and enjoy the
flame effect.
CLEANING
Turn heater OFF and unplug from outlet. Use a vacuum or duster to keep heat and vent
area clean from dust and dirt. The exterior of the fireplace should be cleaned with a
damp cloth or duster. Do not use abrasive cleaners, liquid sprays, or any other cleaner
that may scratch the surface.