beautypg.com

Warning, Electrical requirements, Base grille – Whirlpool 2211657 User Manual

Page 5

background image

5

Electrical Requirements

Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection:

Recommended Grounding Method

A 115 Volt, 60 Hz. (Plug 1), 220/240 Volt/50 Hz (Plugs 2 or 3), or
220 Volt/60Hz (Plug 3) AC only 10 ampere fused and grounded
(earthed) electrical supply is required.

It is recommended that a separate circuit serving only your
refrigerator be provided. Use an outlet that cannot be turned off
by a switch or pull chain. Do not use an extension cord.

NOTE:

Before performing any type of installation, cleaning, or

removing a light bulb, turn the control, (Thermostat, Refrigerator
or Freezer Control depending on the model) to OFF and then
disconnect the refrigerator from the electrical source. When you
are finished, reconnect the refrigerator to the electrical source
and reset the control (Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired setting.

For Australia and New Zealand:

Your new appliance has been especially manufactured to meet all
Australian Standards and Conditions.

Some notations in the installation instructions may refer to
electrical requirements in other countries, so we draw your
particular attention to these specific notes.

Your appliance needs to be plugged into a 230/240 Volt 50 Hz 10
amp (Plug 4) AC only earthed outlet.

Base Grille

To remove the base grille:

1.

Open both refrigerator doors.

2.

Place hands along the ends of the grille, with your thumbs
along the top. Push in with your thumbs and pull up on the
bottom.

NOTE:

Be sure to refasten the Tech Sheet behind the base grille

after cleaning.

To replace the base grille:

1.

Open the doors.

2.

Line up the grille support tabs with the metal clips.

3.

Push the grille firmly to snap it into place.

WARNING

Electrical Shock Hazard

Plug into a grounded (earthed) outlet.

Failure to follow these instructions can result in
death, fire, or electrical shock.

Do not use an extension cord.

Do not use an adapter.

Do not remove ground prong.

Plug 1

Plug 2

Plug 3

Plug 4