White-Westinghouse Top Freezer - Manual (Page 6)

6
Energy Saving Ideas • Locate the refrigerator in the coolest part of the room, out of direct sunlight
and away from heating ducts or registers. Do not place the refrigerator next
to heat-producing appliances such as a range, oven or dishwasher. If this is
not possible, a section of cabinetry or an added layer of insulation between
the two appliances will help the refrigerator operate more efficiently.
• Level the refrigerator so the doors close tightly.
• Refer to this Owner's Guide for the suggested refrigerator settings.
• Periodic cleaning of the condenser will help the refrigerator run more
efficiently. See Outside in the "Care and Cleaning" section.
• Do not overcrowd the refrigerator or block cold air vents. Doing so causes
the refrigerator to run longer and use more energy. Shelves should not be
lined with aluminum foil, wax paper or paper toweling. Liners interfere with
cold air circulation, making the refrigerator less efficient, which could cause
food spoilage.
• Cover foods and wipe containers dry before placing them in the refrigerator.
This cuts down on moisture build-up inside the unit.
• Organize the refrigerator to reduce door openings. Remove as many items as
needed at one time and close the door as soon as possible.
Cool Down Period
To ensure safe food storage, allow the refrigerator to operate with the doors closed
for at least 8 to 12 hours before loading with food.
Refrigerator Control
• Set the refrigerator control dial to the midpoint for a trial period of 24 hours.
• After 24 hours, adjust the control as needed. For colder temperatures, turn the dial
toward COLDEST. For warmer temperatures, turn the dial toward COLD. Adjust
temperatures one increment at a time. The temperature will increase or
decrease, but not necessarily by 1, 2, or 3 degrees.
Freezer Control
• Set the freezer control to the midpoint of the dial for a trial period of 24 hours.
• After 24 hours, adjust the control as needed. For colder temperatures, turn the
dial a notch toward COLDEST. For warmer temperatures, turn the dial a notch
toward COLD. Adjust temperatures one notch at a time.
An adjustment made to one compartment may require an adjustment to the other:
• Turning the refrigerator control will change the temperature in BOTH
compartments. If the refrigerator control is turned to OFF, cooling stops
in both compartments.
• Turning the freezer control will change only the temperature in the freezer
compartment.
To maintain temperatures, a fan circulates air in the refrigerator and freezer
compartments. For good circulation, do not block cold air vents with food items.
Moisture Reduction Switch (some models)
If moisture forms on the metal between the two doors, set the Moisture
Reduction Switch (located on the control box in the refrigerator compartment) to
the “ON” position. A heater will warm the surface and allow moisture to evaporate.
Setting the Controls
Freezer Control
Moisture Reduction Switch
Refrigerator Control